Bambu Lab X1 problems, fixes and parts
Problems the Bambu Lab X1 is known for and how to fix them, plus the replacement parts that fit: hotends, extruder, nozzle wipers, other.
The plain X1 has plastic side panels and shipped without the auxiliary fan, carbon filter and chamber camera, while the X1 Carbon has aluminum side panels and all three fitted.
The complete hotend assembly is sold in separate X1 and P1 versions, and the X1 version does not fit the X1E.
The plain X1 has a stainless nozzle and steel gears, so parts advice written for the X1 Carbon about abrasive filament does not apply until hardened parts are fitted.
The auxiliary fan, carbon filter and chamber camera were upgrades on the X1, so check whether yours has them before buying replacements.
- Known problem: Stock nozzle and extruder gear wear with abrasive filament. Stop printing carbon fiber, glass fiber and glow filament on the stock parts.
- Known problem: Dirty carbon rods cause drag and layer shifts. Power off the printer.
- Known problem: Micro lidar errors. Restart the printer and run the calibration again.
- Known problem: Noisy mainboard fan on early units. Listen at the back of the printer to confirm the noise is the mainboard fan.
- Known problem: AMS cannot pull filament back. Update the printer firmware first.
- Hotend with Nozzle (X1 and P1 series). Fits: X1, X1 Carbon, P1P, P1S
- Complete Hotend Assembly - X1 Series. Fits: X1, X1 Carbon
- Hardened Steel Extruder Gear Assembly. Fits: X1, P1P, P1S
- Nozzle Wiper - X1/P1 Series. Fits: X1, X1 Carbon, P1P, P1S
- Silicone Sock for Hotend. Fits: X1 Carbon, P1P, P1S, X1 (same hotend, but the store listing names the X1C)