Creality CR-10 / CR-10S problems, fixes and parts
Problems the Creality CR-10 / CR-10S is known for and how to fix them, plus the replacement parts that fit: nozzles, extruder.
Both are large open-frame printers with a 300 x 300 x 400 mm build area and a separate control box, and the CR-10S is the one with a filament run-out sensor.
Buying 24 V heaters, fans or hot ends made for the Ender 3. The original CR-10 is a 12 V printer. Check the label on your power supply before ordering any electrical part.
Flashing CR-10 firmware onto a CR-10S or the other way round. The two use different mainboard families, and a CR-10S board must not have a bootloader flashed onto it.
Buying parts for the CR-10S Pro, CR-10 V2 or CR-10 Smart. Those are different printers that share only the name.
- Known problem: Wrong firmware or bootloader for the board. Decide which printer you have. A factory filament sensor points to a CR-10S board.
- Known problem: Slow, uneven bed heating. Allow extra time and let the bed sit at temperature for a few minutes before you print.
- Known problem: Spool on the control box upsets the print. Put the control box on a flat, firm surface.
- Known problem: Bowden tube slipping at the hot end. Heat the hot end and remove the filament.
- Known problem: First layer will not stick to the plain glass bed. Clean the glass.
- MK8 Nozzles Kit 24 PCS. Fits: CR-10, CR-10S
- High-end Hardened Steel Nozzle Kit. Fits: CR-10, CR-10S, CR-10 Mini, CR-10 S4, CR-10 S5
- Metal Extruder Kit (Red). Fits: CR-10, CR-10S
- Sprite Extruder SE. Fits: CR-10