Elegoo Neptune 4 problems, fixes and parts
Problems the Elegoo Neptune 4 is known for and how to fix them, plus the replacement parts that fit: nozzles, hotends, heaters and sensors, build plates,…
The plain Neptune 4 has plastic POM wheels and a single-zone heated bed, while the Neptune 4 Pro has metal guide rails and a two-zone bed; also check whether your print head cable is a flat ribbon or a round Type-C cable.
Print head parts and firmware differ between the ribbon-cable and Type-C versions, so identify your version before ordering.
MK8 nozzles for the Neptune 3 series do not fit. The Neptune 4 uses its own custom nozzle.
Elegoo warns that loading the firmware fix pack on a Type-C version can brick the printer.
- Known problem: Blob of plastic around the hotend. Check the hotend temperature on the screen, because a reading below zero means the sensor is damaged.
- Known problem: Nozzle too close or too far after leveling. Power off and unplug before checking the mechanics.
- Known problem: Nozzle keeps moving down when homing. Switch off at once if the nozzle is pressing on the bed.
- Known problem: MCU shutdown: ADC out of range. Power off, reseat the print head cable, wait a minute and power on.
- Known problem: Loose POM wheel that will not tighten. Leave it alone if the print head is steady and prints look good.
- Known problem: Klipper errors after firmware changes. Identify your printer version first, ribbon-cable or Type-C.
- Known problem: Heated bed not heating at expected rate. Power off and unplug the printer.
- Neptune 4/4 Pro nozzle (B0N0W1/B0N0V1). Fits: Neptune 4, Neptune 4 Pro
- Nozzle assembly (B0N101/B0N1L1). Fits: Neptune 4 (ribbon-cable version)
- Heater and thermistor. Fits: Neptune 4, Neptune 4 Pro
- Teflon (PTFE) tube in the throat pipe. Fits: Neptune 4, Neptune 4 Pro
- Model cooling fan. Fits: Neptune 4 (ribbon-cable version)
- Y-axis timing belt. Fits: Neptune 4
- Extruder cable (B0N1R1). Fits: Neptune 4 (ribbon-cable version)
- PEI spring steel sheet. Fits: Neptune 4