Flashforge Adventurer 3 / Adventurer 3 Lite problems, fixes and parts
Problems the Flashforge Adventurer 3 / Adventurer 3 Lite is known for and how to fix them, plus the replacement parts that fit.
Both are small enclosed cube printers with a 150 mm build area and a clip-in nozzle, and the Lite is the one without a camera or a filament run-out reminder.
- Known problem: Clogged nozzle. Tap Preheat and heat the extruder to 240 C.
- Known problem: Extruder chugs or clicks and no filament comes out. Check that the white guide tube is pushed fully into its joint at both ends.
- Known problem: Temperature reads 300 C or looks wrong after a nozzle swap. Turn the printer off.
- Known problem: Nozzle starts too far from, or too close to, the bed. Tap Setting, then Calibration.
- Known problem: Standard 1 kg spools do not fit the built-in filament bay. Use small spools of about 0.5 kg that fit inside the bay.