Prusa Original Prusa i3 MK2S / MK2.5S problems, fixes and parts
Problems the Prusa Original Prusa i3 MK2S / MK2.5S is known for and how to fix them, plus the replacement parts that fit: nozzles, heaters and sensors,…
The MK2S has a PEI sheet glued to the bed, while the MK2.5S has a magnetic bed with a removable steel sheet and a filament sensor on top of the extruder; both are 12 V printers, unlike the 24 V MK3 family.
These printers run on 12 V. Prusa warns not to buy 24 V parts, so MK3 heaters and other 24 V electrical parts must not be fitted.
The MK2S and MK2.5S take different hotend PTFE tubes: 50 mm for the MK2S and 44.3 mm for the MK2.5S.
The MK2S bed has PEI glued on, so it needs the adhesive PEI-Ultem sheet. A removable steel sheet only works on the magnetic bed of the MK2.5 and MK2.5S.
- Known problem: MINTEMP error in a cool room. Move the printer to a room above 20 °C and away from drafts.
- Known problem: Wrong voltage parts fitted. Stop using the printer if a part of the wrong voltage has been fitted.
- Known problem: Filament sensor gives false readings. Check that the firmware is the MK2.5S version.
- Known problem: Clogs from a worn or loose hotend PTFE tube. Try a cold pull first if filament still loads and unloads.
- Nozzle V6 0.4 mm. Fits: MK2S, MK2.5S
- Hotend PTFE tube (MK2/S, MK2.5, MK3, MMU2). Fits: MK2, MK2S, MK2.5, MK3
- Hotend PTFE tube (MK2.5S, MK3S, MMU2S). Fits: MK2.5S, MK3S
- Hotend thermistor. Fits: MK2, MK2S, MK2.5, MK2.5S, MK3, MK3S, MK3S+
- PEI-Ultem sheet. Fits: MK2, MK2S (PEI glued to the heatbed)
- Smooth PEI Print Sheet. Fits: MK2.5, MK2.5S (magnetic bed)
- Linear bearing LM8UU. Fits: MK2, MK2S, MK2.5, MK2.5S
- IR filament sensor. Fits: MK2.5S (with the IR Filament sensor cable MK2.5S)