Prusa Original Prusa i3 MK3S / MK3S+ problems, fixes and parts
Problems the Prusa Original Prusa i3 MK3S / MK3S+ is known for and how to fix them, plus the replacement parts that fit: nozzles, hotends, heaters and…
The MK3S and MK3S+ open the extruder idler door with one spring screw (the older MK3 has two), and the MK3S+ uses the SuperPINDA bed probe while upgraded MK3.5 and MK3.9 printers have a new LCD and mainboard.
The hotend PTFE tube comes in three lengths. The MK3S+ takes 42.3 mm, the MK3S takes 44.3 mm and the MK3 takes 50 mm, and they do not swap.
MK2 and MK2.5 parts are 12 V and the MK3 family is 24 V, so heaters and fans from the older printers must not be fitted here.
Nextruder nozzles for the MK4 do not fit this printer. It takes standard V6 nozzles.
- Known problem: Filament sensor gives false readings. Check that the firmware is the S or S+ version for your printer.
- Known problem: Heat creep clogs with PLA. Clear the clog first using Prusa's clogged hotend guide.
- Known problem: Clogs from a worn or loose hotend PTFE tube. Try a cold pull first if filament still loads and unloads.
- Known problem: MINTEMP error from a broken thermistor wire. Make sure the room is above 20 °C and the printer is out of drafts.
- Known problem: Plastic blob around the hotend. Heat the nozzle to about 250 °C for PLA or 280 °C for PETG or ABS and hold it there for at least 5 minutes.
- Known problem: Hotend fan stops or reports an error. Power off, unplug and open the electronics cover.
- Known problem: Rattling from the bed after many hours. Move each axis from the menu to find which one makes the noise.
- Nozzle V6 0.4 mm. Fits: MK3, MK3S, MK3S+, MK3.5, MK3.5S
- Hotend PTFE tube (MK3S+, MMU2S). Fits: MK3S+, MK3S+ with MMU2S
- Hotend PTFE tube (MK2.5S, MK3S, MMU2S). Fits: MK3S, MK2.5S, MK3S or MK2.5S with MMU2S
- Assembled hotend (for MK3 series). Fits: MK3, MK3S, MK3S+, MK3.5, MK3.5S
- Hotend thermistor. Fits: MK3, MK3S, MK3S+, MK3.5, MK2, MK2S, MK2.5, MK2.5S
- Hotend heater cartridge 24V 40W (MK3/S/+). Fits: MK3, MK3S, MK3S+
- Hotend fan MK3/S/+. Fits: MK3, MK3S, MK3S+, MK3.5, MK3.5S, MK2.5 and MK2.5S with a v-cable adapter
- Print fan (MK3/S/+, MINI/+). Fits: MK3, MK3S, MK3S+, MK3.5, MK3.5S, MINI, MINI+
- Smooth PEI Print Sheet. Fits: MK3, MK3S, MK3S+, MK2.5, MK2.5S, other MK series printers with the magnetic bed