Prusa Original Prusa MK4 problems, fixes and parts
Problems the Prusa Original Prusa MK4 is known for and how to fix them, plus the replacement parts that fit: nozzles, build plates, other.
A stock MK4 has the Nextruder print head without the large 360 degree cooling fan and shroud that the MK4S and upgraded MK4 printers have.
Ordinary V6 nozzles from an MK3S+ do not fit the MK4 unless the Nextruder V6 Nozzle Adapter is installed.
The MK4 spare parts bundle is not for the MK4S, and the MK4S spare parts are not all for the MK4, so match the part to how your printer is built today.
The MK4 to MK4S upgrade kit comes in two versions for the older and newer display. Compare your display with the photos on Prusa's page before ordering.
- Known problem: Nozzle cleaning failed error. Heat the nozzle to 250 °C for a few minutes and clean it with a small brass brush, keeping the brush away from the wires.
- Known problem: Under-extrusion from a nozzle that is not fully seated. Turn the printer off and let it cool fully.
- Known problem: Stuck filament detected pauses. Press unload, let the printer unload, then load the filament again to resume.
- Known problem: Plastic blob around the hotend. Heat the nozzle to about 250 °C for PLA or 280 °C for PETG or ABS and hold it there for at least 5 minutes.
- Known problem: Weaker overhang cooling than the MK4S. Slow down overhangs or use a quality profile in PrusaSlicer.
- Prusa Nozzle brass. Fits: MK4, MK4S, MK3.9, MK3.9S
- Prusa Nozzle brass CHT. Fits: MK4, MK4S, MK3.9, MK3.9S
- Prusa Nozzle ObXidian. Fits: MK4, MK4S, MK3.9, MK3.9S
- Nextruder V6 Nozzle Adapter. Fits: MK4, other Nextruder printers listed on Prusa's page
- Spare Parts Bundle (for MK4). Fits: MK4, MK3.9
- Smooth PEI Print Sheet. Fits: MK4, MK4S, other MK series printers with the magnetic bed
- Original Prusa MK4 to MK4S upgrade kit. Fits: MK4