Inconsistent first layer across the bed
The first layer is squashed flat in some areas and loose or patchy in others. The bed isn't the same distance from the nozzle everywhere, even if your printer has automatic bed leveling.
Fixes, in the order to try them:
- Heat the bed to printing temperature before leveling, since beds change shape as they warm.
- Tram the bed corners first with paper or a feeler gauge at each corner, then run auto-leveling.
- Clean under the flexible plate and wipe the magnetic base.
- Tighten bed wheels until the bed doesn't wobble but still rolls smoothly, and swap soft springs for silicone spacers.
- Make sure the start code loads or builds the mesh on every print; your printer's guide lists the right command.
- Measure both ends of the gantry from the frame and level it if one end is higher.
- Set the Z offset (nozzle height after leveling) with a live first-layer test once the bed is level.