How to calibrate flow (extrusion multiplier)
Flow, also called the extrusion multiplier or flow ratio, scales how much plastic the printer pushes out for every line. Calibrating it with your slicer's built-in test gives smooth top surfaces and accurate walls, and it's worth doing for each new filament brand.
Fixes, in the order to try them:
- Load the filament, then select its profile, your nozzle size and your plate type in the slicer
- Start the coarse flow rate test, which prints a set of squares with different flow settings
- When it finishes, look at the top of each square under a bright light and run a finger across it
- Pick the smoothest square with no gaps and no raised ridges
- Apply that square's value to the filament's flow ratio, using the slicer's dialog or the formula its guide shows
- Run the fine test if your slicer offers one, and pick the best square again
- Save the filament profile under a clear name, such as brand, material and color
- Print a small part with a flat top to confirm; most results land close to 1.0, often about 0.9 to 1.05