How to tune pressure advance for sharp corners
Pressure advance, called linear advance in some firmware, makes the extruder push a little early when the print speeds up and ease off before it slows down, because melted plastic lags behind the extruder gear. Tuning it gives sharp corners, even lines and fewer blobs, especially at high speed.
Fixes, in the order to try them:
- Open the pressure advance or flow dynamics test from your slicer's Calibration menu, or use the printer's automatic calibration if it has one
- Choose the pattern method if offered, since its corners are the easiest for beginners to read
- Set a starting range of about 0 to 0.1 for direct drive, or 0 to 1 for Bowden
- Print the test and find the line or corner that is sharpest, with no bulge and no gap
- Read the value printed beside the best line, or count the steps from the start value
- Enter it in the filament profile's pressure advance setting, or save it in the calibration dialog
- Print a small cube; if corners still bulge, raise the value slightly, and if they show gaps, lower it
- Rerun the test when you change filament type, nozzle size or extruder