How to find a filament's best temperature with a temperature tower
A temperature tower is a test print made of stacked sections, each printed a few degrees cooler than the one below, so you can see which temperature looks and holds best. It takes under an hour and is the first calibration to run on a new filament.
Fixes, in the order to try them:
- Set the tower to cover the label's range in 5°C steps, with the hottest section at the bottom
- Print it at the speed you normally use, since the best temperature changes with speed
- Look at each section for strings, blobs and a shiny, droopy surface, which mean too hot
- Look for rough walls, gaps and poor overhangs or bridges, which mean too cool
- Once the tower is cool, try bending or snapping it at a few sections; layers that break easily were too cold to bond
- Pick the section with the best balance, and go about 5°C hotter if the part needs strength
- Set that temperature in the filament profile and save it
- Run the tower again if you change nozzle size or print much faster