Elephant's foot (flared first layers)
The bottom few layers of the print bulge outward, so the base is wider than the rest of the part. It happens when the first layers are squished too much, or stay soft from bed heat while the weight above presses down.
Fixes, in the order to try them:
- Raise the Z offset slightly, about 0.02 to 0.05 mm.
- Lower the bed temperature by 5°C, staying inside the range on the filament label.
- Turn on elephant foot compensation in the slicer, starting around 0.1 to 0.2 mm.
- Lower the first layer flow if your slicer has a separate setting for it.
- Add a small chamfer (an angled edge) of about 0.5 mm to the bottom edge of the model.