Extruder clicking or skipping
The extruder makes a clicking or knocking sound and the filament stops feeding smoothly. The motor is pushing, but the filament can't move forward, so the drive gear slips back.
Fixes, in the order to try them:
- Raise the Z offset slightly if it clicks only on the first layer.
- Slow down or lower the slicer's maximum volumetric speed, and try 5 to 10°C hotter within the label's range.
- Clear a partial clog with a cleaning needle or a cold pull (heating, then pulling filament out as it cools), heating the nozzle first as your printer's guide describes.
- Set the idler tension so the gear grips the filament firmly without crushing or flattening it.
- Untangle the spool and make sure it turns freely and the filament path has no sharp bends.
- Reduce retraction distance if notches appear at regular spots along the filament.
- Brush plastic dust out of the drive gear teeth once the printer has cooled down.