Tangled spool, snagged filament or running out mid-print
The print suddenly stops getting plastic, the extruder clicks, or the spool won't turn because the filament is knotted or caught on something. Tangles usually start when a loose end slips under other wraps in storage, and running out mid-print is easy to prevent with a runout sensor and a quick check before long jobs.
Fixes, in the order to try them:
- Pause the print as soon as you notice so the extruder doesn't keep grinding the filament
- Heat the hotend, unload the filament, and cut off any flattened or chewed section
- Unwind the spool slowly to find the crossed wrap, free it, and rewind the loose filament neatly under light tension
- Reload and resume the paused print if your printer supports it, or start the print again
- Make sure the spool spins freely; add a holder with bearings or rollers if it drags
- Route the filament so it reaches the extruder or tube in a gentle curve with no sharp bends
- Turn on the runout sensor in the printer settings so it pauses when filament ends
- Before long prints, compare the slicer's filament weight estimate with what's left on the spool