My first print: a checklist
If you just set up your printer, a few basic steps prevent most early failures. Most first prints fail because of a dirty bed, a nozzle set too high or too low, or damp filament, not a broken printer.
Fixes, in the order to try them:
- Run the printer's built-in calibration or auto bed leveling once, with the bed already heated.
- Wipe the bed with isopropyl alcohol and keep your fingers off the printing surface afterward.
- Start with PLA, the easiest material, using your slicer's preset for your exact printer and that filament.
- Print the sample model that came with the printer before trying your own designs.
- Watch the first layer closely: lines should look flat, slightly squished and touching, with no gaps.
- If the first layer peels up, lower the Z offset a little, and if the nozzle scrapes the bed, raise it.
- If the first layer still won't stick, wash the bed with dish soap and warm water, then rinse and dry it.
- Store the spool sealed with desiccant (moisture-absorbing packets) between prints.