Heat creep (jams partway through long prints)
The print starts fine, then stops extruding after a while because heat travels up the hotend and softens filament where it should stay solid. The softened plastic swells and jams, usually because the hotend's cooling fan isn't keeping up.
Fixes, in the order to try them:
- Let the hotend cool, then clean the heatsink fins and check that the hotend fan spins freely.
- Replace a noisy, slow or stopped hotend fan with one of the same size and voltage.
- Open the enclosure door or remove the lid when printing PLA.
- Shorten retraction toward the low end for your printer type.
- Clear the current jam by heating the nozzle and pulling the filament out, then do a cold pull if needed.
- Re-seat the heat break following the hotend maker's instructions, using thermal paste only where they call for it.