Layer shifting
Partway up, the print suddenly continues offset to one side, like a stack of plates pushed sideways. The motors lost their position, usually because a belt or pulley slipped or the nozzle bumped into the print.
Fixes, in the order to try them:
- Tension the belts so they feel firm and twang like a low guitar string, using the built-in tensioner if there is one.
- Tighten the small set screws on the motor pulleys, making sure one sits on the flat side of the shaft.
- Check that cables, the filament path and nearby objects can't catch on the moving parts.
- Fix any curling or warping first, since the nozzle hitting raised edges is a common trigger.
- Turn on z-hop (lifting the nozzle slightly for travel moves) if the nozzle catches on the print.
- Lower outer wall speed, travel speed or acceleration, especially on printers where the bed slides front to back.
- Make sure the mainboard fan runs and the vents under the printer aren't blocked.