Multi-color unit won't load, cut or change colors cleanly
Your multi-color unit, such as an AMS, CFS, ACE or MMU, stops with a load or cutter error, or color changes leave streaks and blobs of the wrong color. Most problems come from a bad filament tip, a snag somewhere in the spool path, or purge settings that are too small.
Fixes, in the order to try them:
- Trim the filament end to a clean, sharp angle with flush cutters before loading
- Unload all slots and clear any broken pieces from the tubes, hub and toolhead
- Check every PTFE tube for kinks or crushed ends, trim or replace them, and push them fully into their fittings
- Fit cardboard spools with an adapter ring or move the filament to a plastic spool so it can't slip or shed dust
- Raise the purge or flush volume in the slicer, especially for dark to light changes
- Purge into the infill or a prime tower, an extra block that soaks up color changes, to cut streaks and waste
- Dry brittle or damp filament before putting it back in the unit
- If cutter errors keep coming, let the hotend cool, then inspect and clean or replace the cutter blade using the maker's guide