Nozzle scraping or dragging across the print
The nozzle rubs or catches on the print as it moves, leaving scratches or making a clicking or knocking sound. Usually part of the print sits higher than it should, from too much plastic or from edges curling up.
Fixes, in the order to try them:
- Run the slicer's flow calibration and set the flow ratio from the result.
- Fix warping first with a clean bed, the right bed temperature and a brim if needed.
- Improve cooling on overhangs so their edges don't curl up.
- Enable Z-hop, a small lift on travel moves, of 0.2 to 0.4 mm, at least over top surfaces.
- Turn on avoid crossing walls, sometimes called avoid crossing perimeters, so travel moves go around the part.
- Switch infill to gyroid or cubic, which don't cross themselves on a single layer.
- Raise the Z offset slightly if the first layer looks over-squashed.