Over-extrusion, blobs, and rough walls
Too much plastic is coming out, so walls bulge, surfaces look rough and parts come out slightly too big. Usually the flow setting is too high, or the slicer thinks the filament is thinner than it really is.
Fixes, in the order to try them:
- Run the flow calibration test in Bambu Studio or OrcaSlicer (see the flow calibration guide for other slicers) and use the best-looking result.
- Without a test, lower flow in 2% steps and check the print again each time.
- Measure the filament with calipers and enter the real diameter in the slicer if it differs.
- Lower the nozzle temperature 5°C at a time, staying inside the label range.
- Make sure the nozzle size in the slicer matches the nozzle installed.
- Calibrate pressure advance to stop bulges at corners and seams.