Print stuck to the bed and how to remove it safely
The print won't come off the build plate, or you're worried about scratching or tearing the plate by prying. Let the bed cool completely and flex the plate before reaching for tools; most stuck prints come from a first layer pressed too hard or PETG bonding to a smooth surface.
Fixes, in the order to try them:
- Let the bed cool completely; many parts pop loose on their own as the plastic shrinks
- Take off a flexible plate and bend it gently in a few directions, without folding or creasing it
- Put a removable steel plate in the freezer for about 10 minutes, then flex it again
- Slide a thin plastic scraper in from a corner at a low angle; never use a metal blade on a coated plate
- With the printer off and cold, drip a little isopropyl alcohol under a lifted edge and let it soak in before flexing again
- If glue stick was used, rinse a removable plate under warm water to dissolve it, then dry the plate fully
- Next time, raise the Z offset, the nozzle's height on the first layer, by about 0.02 to 0.05 mm
- Lower the bed temperature 5 to 10°C if parts keep sticking too hard once cool