PETG stuck to the bed or ripped the surface
PETG prints are welded to the bed, or they tear pieces out of the bed surface when you remove them. PETG sticks very strongly to smooth PEI (a common plastic bed coating) and to glass, especially when the nozzle is set close.
Fixes, in the order to try them:
- Apply a thin layer of glue stick as a release layer on smooth PEI or glass before printing PETG.
- Raise the Z offset slightly, about 0.02 to 0.05 mm, so the first layer isn't pressed so hard.
- Lower the bed temperature toward 70°C, the low end of PETG's usual 70 to 85°C range.
- Print PETG on a textured PEI sheet, which grips it well while hot but releases cleanly when cool.
- Let the bed cool completely, then flex the sheet to pop the part off.
- On glass, use a plastic scraper once everything is cool, and never pry with a metal blade that can chip the glass or cut you.