Holes and bumps on top surfaces (pillowing)
The flat top of your print has small holes, lumpy bumps or a quilted look where the top layers sagged into the gaps of the infill, the sparse inner fill pattern. This is called pillowing, and it usually means there are too few solid top layers or the cooling fan can't set them fast enough.
Fixes, in the order to try them:
- Raise the top layer count so the top skin is at least 0.8 to 1 mm thick, for example 5 layers at 0.2 mm
- Increase infill to about 15 to 20 percent, or use gyroid infill, which supports the top more evenly
- Run the part cooling fan at 100 percent for top layers on PLA
- Slow the top surface speed, starting at about half your normal wall speed
- Lower the nozzle temperature by 5°C if top lines look glossy and saggy
- Turn on ironing for flat tops, which makes the nozzle pass again with a tiny flow to smooth the surface
- If small holes remain, run a flow calibration so the printer pushes out the right amount of plastic