Zits, blobs, and visible seams
You see small bumps lined up on one side of the part, or random pimples scattered over the walls. They form where the nozzle starts and stops each loop of wall, when a little extra plastic leaks out.
Fixes, in the order to try them:
- Set the seam position to aligned, rear or nearest corner so the seam lands on a hidden edge.
- Turn on pressure advance (also called linear advance) and calibrate it with the slicer's built-in test, which evens out pressure at starts and stops.
- Run a retraction test and use the cleanest value, often 0.5 to 1.5 mm for direct drive or 3 to 6 mm for Bowden (tube-fed) printers.
- Enable wipe on retract, which drags the nozzle along the wall as it stops, or try a small coasting value.
- Lower the outer wall speed, for example by about a third, so the outside surface prints more evenly.
- Lower the nozzle temperature 5°C at a time, staying within the label's range.
- Try the scarf seam option if your slicer offers it, which tapers each loop's start and end together.
- Dry the filament if the blobs come with popping sounds.