Spaghetti (print failed and came loose)
You come back to a tangle of plastic where your print should be, because the part broke loose or a section failed and the printer kept extruding into the air. The root cause is usually poor bed adhesion, warping, or a weak support.
Fixes, in the order to try them:
- Fix adhesion first (see 'First layer won't stick').
- Add a brim and slow down tall, narrow parts.
- Rotate the model so its widest flat face sits on the bed.
- Add or strengthen supports, for example with tree supports or more support walls.
- Turn on spaghetti or failure detection if your printer has a camera.
- If plastic is wrapped around the nozzle, heat it to printing temperature and peel the blob off carefully with pliers; never pry it off cold.
- After removing a blob, check that the heater and temperature sensor wires weren't pulled loose.