Supports are hard to remove or scar the part
Supports stick to the part so firmly that they're hard to remove, or they leave rough scars behind. Most of the time the gap between the support and the part is too small, or supports landed on a surface you care about.
Fixes, in the order to try them:
- Set support Z distance to about one layer height, such as 0.2 mm for 0.2 mm layers, and raise it a little if supports still stick.
- Try tree or organic supports, which touch the model in fewer, smaller spots.
- Use 2 to 3 interface layers with lower density or wider spacing so the top separates cleanly.
- Increase the support XY distance if supports stick to walls.
- Orient the part so supports land on hidden faces, or paint where supports go with the slicer's blocker and enforcer tools.
- On multi-material printers, print the support interface in a material that doesn't bond to the part, or use dissolvable support filament.
- Remove supports with flush cutters and pliers, pulling them away from the part instead of prying against thin features.