Z-banding and inconsistent layers
Horizontal bands or ripples run up the sides of the print, often repeating at the same spacing. They usually come from a wobbly or dirty Z lead screw (the threaded rod that raises the print head or bed) or from uneven extrusion.
Fixes, in the order to try them:
- Clean the lead screws and apply a thin coat of suitable lubricant.
- Check the Z coupler screws are tight and the lead screw runs straight.
- On most printers with 8 mm lead screws, use layer heights in multiples of 0.04 mm, such as 0.12, 0.16, 0.2 or 0.28 mm.
- Run PID tuning (a calibration that steadies the heater) on the hotend and bed.
- On printers with wheels, adjust them so they roll smoothly with no wobble or tight spots.
- If the bands are irregular, calibrate flow and check the filament diameter.